Azo-bridged triazoles： Green energetic materials 免费阅读 下载全文 In this short review, excerpts from the literature of azo-bridged triazoles(mainly 1,2,4-triazoles), some of their derivatives(chloromethyl,dinitro and trinitro pyrazole substituted ones, etc.) and some of their salts, have been presented focusing on the most recent investigations. These classes of compounds, known as high nitrogen compounds, are generally high energy density materials. Therefore, if available some of their ballistic properties were included.
Friction assisted solid state lap seam welding and additive manufacturing method 免费阅读 下载全文 This paper describes results of seam welding of relatively high temperature melting materials, AISI 304, C-Mn steels, Ni-based alloys, CP Cu, CP Ni, Ti6Al4V and relatively low temperature melting material, AA6061. It describes the seam welding of multi-layered similar and dissimilar metallic sheets. The method described and involved advancing a rotating non-consumable rod(CP Mo or AISI 304) toward the upper sheet of a metallic stack clamped under pressure. As soon as the distal end of the rod touched the top portion of the upper metallic sheet, an axial force was applied. After an initial dwell time, the metallic stack moved horizontally relative to the stationery non-consumable rod by a desired length, thereby forming a metallurgical bond between the metallic sheets. Multi-track and multi-metal seam welds of high temperature metallic sheets, AISI 304, C-Mn steel,Nickel-based alloys, Cp Cu, Ti6Al4V and low temperature metallic sheets, AA6061 were obtained. Optical and scanning electron microscopy examination and 180 degree U-bend test indicated that defect free seam welds could be obtained with this method. Tensile- shear testing showed that the seam welds of AISI 304, C-Mn steel, Nickel-based alloy were stronger than the starting base metal counterparts while AA6061 was weaker due to softening. The metallurgical bonding at the interface between the metallic sheets was attributed to localized stick and slip at the interface, dynamic recrystallization and diffusion. The method developed can be used as a means of welding, cladding and additive manufacturing.
Ballistic behavior of boron carbide reinforced AA7075 aluminium alloy using friction stir processing -An experimental study and analytical approach 免费阅读 下载全文
Optimization of three-loop missile autopilot gain under crossover frequency constraint 免费阅读 下载全文
Enhancement of seal life through carbon composite back-up rings under shock loading conditions in defence applications 免费阅读 下载全文 The life of Nitrile Butadiene Rubber(NBR) O-ring seal having shore hardness of A70 and A90 under shock loading conditions was investigated by a specially designed pneumo-hydraulic shock test rig. Shock tests have been carried out on bare seals, seal with conventional polytetrafluoroethylene(PTFE) back-up rings and seal with newly developed carbon composite back-up rings to study its behaviour under different operating conditions until failure. Experiments were conducted by varying annular gap ranging from 0.3 to 0.5 mm, oil temperature from 30 ℃ to 70 ℃ and rate of pressure rise from 600 to 2400 MPa/s. Significant enhancement in seal life was observed with carbon composite back-up ring at reduced annular clearances compared to seal life with conventional PTFE back-up ring and without back-up rings.
Studies on impact sensitivity of nanosized trinitrotoluene （TNT） confined in silica processed by sol-gel method 免费阅读 下载全文
Effect of fibre orientations on the mechanical properties of kenaf-aramid hybrid composites for spall-liner application 免费阅读 下载全文